Prices are without shipping, buyer to pay actual shipping cost. Links to the power supply and other parts used can be found on the main page for the project.
Preassembled Resin Wash Station V1
US $40.00
Includes assembled and programmed Resin Wash Station controller. You will need to fine tune the stepper driver to the output current required by your selected stepper motor. Prewired JST pigtails included for switch wiring. Pre-assembled boards will include the jumper fix needed, as well as the buck tuned to 8 volts.
Resin Wash Station V1 DIY Kit
$25.00
Includes all components required to make the Resin Wash Station Controller, including PCB, the Arduino, stepper driver, and the buck converter, and the JST pigtails. The Arduino Nano is pre-programmed.
If you don’t want any of the JST parts, I’ll do $20 on the kit. You can definitely solder your switch leads directly to the pads on the board if you choose.
The kit requires some soldering skills and of course soldering equipment. All components are through hole and anybody with soldering experience should not have any difficulty putting the board together. However, I do not recommend this as a first soldering project.
You must be logged in to post a comment.